Lenovo ThinkServer RD330 Hardware Maintenance Manual page 96

1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Remove the server cover. See "Removing the server cover" on page 69.
4. Remove the riser card assembly 1 and lay it upside down on a flat, clean, and static-protective surface.
See "Replacing the riser card assembly 1" on page 143.
Note: Usually an Ethernet card is installed on the riser card assembly 1 and also can be installed in
any PCI Express card slot that supports it. See "Rear view of the server" on page 20 to identify the
PCI Express card slots of your server.
5. Locate the PCI Express card slot for installing the Ethernet card, and then remove the PCI Express card
slot bracket from the riser card assembly 1. Store the PCI Express card slot bracket in the event that
you later remove the Ethernet card and need the bracket to cover the place.
Figure 39. Removing a PCI Express card slot bracket
6. Touch the static-protective package that contains the Ethernet card to any unpainted surface on the
outside of the server. Then, take the Ethernet card out of the package.
Note: Carefully handle the Ethernet card by its edges.
82
ThinkServer RD330 Hardware Maintenance Manual