Advertisement
18.
The first time you require water out of the dispenser, there will be a delay while the water
reservoir fills up.
19.
Run a further 3 litres (3 qt) through the system, stopping intermittently to ensure the reservoir
is flushed out. Failure to do this will result in excessive dripping from your dispenser.
Important!
•
All connections must be checked for leaks.
•
If unsure of connection process and/or leaks then contact your local plumber to
install and check the system for you.
•
Ensure white 6 mm (¼") tubing is routed away from sharp objects, sharp
corners (beware of kinking tube as this will stop water flow), clear of the
refrigerator unit compartment and not in a location where it can be squashed.
•
Ensure all push-fit connections are firmly pushed into place. The tube should
push in 20 mm (¾") before reaching the stop.
•
If tubing is removed at any point, re-cut the end and re-insert. Tubing must be
fully inserted to avoid leaks.
•
To remove tube from connection points, turn off the isolating tap, push in the
collet and gently pull tubing at the same time.
Fig.8 Connection to water supply
Refer to page 24 - 25, About Freezer compartment, for instructions on the first use
of the ice maker and water dispenser.
Diagram 9
vegetables
24
Advertisement
