Frigidaire FGDS3065KB - 30' Dual Fuel Slide-In Lery SS Group Installation Instructions Manual page 2

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
NOTE:
1. Do not pinch the power supply cord or the
flexible gas conduit between the range and
the wall.
2. Do not seal the range to the side cabinets.
3. 24" (61 cm) minimum clearance between
the cooktop and the bottom of the cabinet
when the bottom of wood or metal cabinet is
protected by not less than ¼" (0.64 cm) flame
retardant millboard covered with not less than
No. 28 MSG sheet metal, 0.015"(0.4 mm)
stainless steel, 0.024"(0.6 mm) aluminum, or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance when the
cabinet is unprotected.
4. For cutouts below 22 7/8"(58.1 cm), appliance
will slightly show out of the cabinet.
5. Allow at least 19 ¼" (48.9 cm) clearance for
door depth when it is open.
*** IMPORTANT:
than 30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening while
pushing into it. Raise leveling legs at a higher position than the cabinet height (see page
3), insert the appliance in the counter and then level.
by the leveling legs and NOT by the cooktop itself.
IMPORTANT:
Cabinet and countertop
width should match the cutout width.
A. HEIGHT B. WIDTH
(Under Cooktop)
35 7/8" (91,1 cm) 30" (76,2 cm)
36 5/8" (93 cm)
(Models with an Electric Oven and a Gas Cooktop)
To avoid cooktop breakage for cutout width (E dimension) of more
E
E
C. COOKTOP
D. TOTAL DEPTH TO
WIDTH FRONT OF RANGE
31 1/2" 28 5/16" (71,9 cm)
(80 cm)
21¾"
(55.25 cm)
Door
Open
B
Make sure the unit is supported
22 7/8"(58.1 cm) min.
23 1/4"(59.05 cm) max.
FRONT OF
CABINET
E. CUTOUT WIDTH***
(Countertop
and cabinet)
30±1/16" 21 3/4" (55,2 cm) Min.
(76,2±0,15 cm) 22 1/8" (56,2 cm) Max
24" (61 cm) Min. with
2
D
C
A
Side Panel
(see Note 4)
1 1/8"
(2.86 cm)
F
Ref.
F. CUTOUT G. HEIGHT
DEPTH OF COUNTERTOP
35 7/8" (91,1 cm) Min.
36 5/8" (93 cm) Max.
backguard