Handle Positions; Height Adjustments - Bissell Trilogy® Vacuum User Manual

O
perations

handle positions

1. In upright position, tilt cleaner back on
its rear wheels to transport from room to
room. The vacuum can also be moved
by using the carrying handle on front of
the vacuum.
2. Using your foot, press handle release
pedal on the lower left side of the
vacuum to recline vacuum in cleaning
position.
note: the brush will only rotate
when vacuum is in reclined
cleaning position, it will not
rotate when in upright position.

height adjustments

turn dial on powerfoot to adjust to
one of 7 height adjustments:
lowest setting – for low pile carpet
or bare floors.
Medium settings – for medium pile
carpet.
high setting – For high pile and
most shag carpet. Adjust to high setting
if difficult to push.
note: for optimal carpet
cleaning performance adjust
to lowest practical setting. if
your vacuum is difficult to push,
adjust to the next higher setting.
If the dial is difficult to turn, tilt the
cleaner back slightly to take the weight
off of the foot while turning.
w w w . b i s s e l l . c o m
attention:
Some Berber carpets have a tendency to
fuzz with wear. Repeated strokes in the
same area may aggravate this condition.
Consider setting your cleaner on a higher
than normal setting for this type of carpet.
notice:
While vacuuming, certain carpets and
low humidity conditions may generate
small static discharges. The discharges
are entirely harmless and are not
associated in any way with the main
power supply.
8 0 0 . 2 3 7 . 7 6 9 1
Handle
release
Pedal
7