Table of Contents
Advertisement
A Error Messages and Indicators
Desktop Board D915PGN/D915PSY/D915PCY/D915PCM reports POST errors in two ways:
•
By sounding a beep code
•
By displaying an error message on the monitor
BIOS Beep Codes
The BIOS beep codes are listed in Table 15. The BIOS also issues a beep code (one long tone
followed by two short tones) during POST if the video configuration fails (a faulty video card or no
card installed) or if an external ROM module does not properly checksum to zero.
Table 15.
Beep Codes
Number of Beeps
1
2
3
4
5
6
7
8
9
10
11
Description
Refresh failure
Parity cannot be reset
First 64 K memory failure
Timer not operational
Processor failure (Reserved; not used)
8042 GateA20 cannot be toggled (memory failure or not present)
Exception interrupt error
Display memory R/W error
(Reserved; not used)
CMOS Shutdown register test error
Invalid BIOS (such as, POST module not found)
65
Advertisement
Table of Contents
