Nokia E72 User Manual page 144

Proxy server address — Enter the address of the proxy
server.
Proxy port number — Enter the port number of the proxy
server.
WLAN internet access points
Select Menu Ctrl. panel
>
Destinations Access
>
on the display. Or, open one of the access point groups,
select an access point marked with
Use the instructions provided by your service provider to
edit the following:
WLAN network name — Select
Search for networks. If you select an existing network,
WLAN network mode
determined by the settings of its access point device.
Network status — Define whether the network name is
displayed.
WLAN network mode — Select
hoc network, and to allow devices to send and receive data
directly; a WLAN access point device is not needed. In an
ad hoc network, all devices must use the same WLAN
network name.
WLAN security mode — Select the encryption used:
WEP, 802.1x, or WPA/WPA2. (802.1x and WPA/WPA2 are
not available for ad hoc networks.) If you select
network, no encryption is used. The WEP, 802.1x, and
WPA functions can be used only if the network supports
them.
144
Settings and Connection
>
point, and follow the instructions
, and select Edit.
Enter manually
and WLAN security mode
Ad-hoc to create an ad
Use access point — Select
device to ask for confirmation before the connection using
this access point is created or
device to connect to the destination using this access point
automatically.
To enter the settings for the selected security mode, select
>
WLAN security
Advanced WLAN settings
Select Options
following:
IPv4 settings — Enter the IP address of your device, the
subnet IP address, the default gateway, and the IP
or
addresses of the primary and secondary DNS servers.
Contact your internet service provider for these addresses.
are
IPv6 settings — Define the type of DNS address.
Ad-hoc channel (only for ad hoc networks) — To enter a
channel number (1-11) manually, select
Proxy server address — Enter the address for the proxy
server.
Proxy port number — Enter the proxy port number.
Packet data (GPRS) settings
Select Menu
Packet data.
Open
Your device supports packet data connections, such as
GPRS in the GSM network. When you are using your device
in GSM and UMTS networks, it is possible to have multiple
After confirmation
Automatically
settings.
Advanced settings
>
Ctrl. panel Settings
> >
to set the
to set the
and from the
User defined.
and Connection
>