Toshiba 46RV525RZ Owner's Manual page 5

37) ALWAYS unplug the TV to completely disconnect
from mains power. When the TV is turned off using
the on/off switch, it is not completely disconnected
from power and a minute amount of current is still
consumed.
38) During normal use, the TV may make occasional
snapping or popping sounds. This is normal,
especially when the unit is being turned on or off. If
these sounds become frequent or continuous, unplug
the power cord and contact aToshiba Authorized
Service Center.
42) If you have the TV serviced:
• Ask the service technician to use only replacement
parts specified by the manufacturer.
• Upon completion of service, ask the service
technician to perform routine safety checks to
_.
det~_~J!!~
__!ha!..!he}V is in
safe_~e~~~~9-_~on~~~?..n..:_
43) The cold cathode fluorescent lamp in the LCD panel
contains asmall amount of mercury.
When the TV reaches the end of its useful life,
dispose of the used TV by the approved method for
your area, or ask a qualified service technician to
properly dispose of the TV.
Note: The lamp(s) inside this product
. - - . - - - - - - - - - - ~ - - - - - - - - - ~ ~ - - ~ - ~ - - - - ~ - - - I
I
I
I
I
I
I
I
39)
Lh
DANGER: RISK OF SERIOUS
i
PERSONAL INJURY OR DEATH!
i
• .. _ "l"'ll!'b.
II
0
J )
"'.~~~~
Never strike the screen
~
I
___
~~l:cl_ sh_a:_o_rh_::'~_. .~_~!;;~
I
40) • The LCD screen of this product can be damaged
i
by ultraviolet radiation from the sun. When
II
selecting a location for the television, avoid
I'
locations where the screen may be exposed to
direct sunlight, such as in front of a window.
I
• Never touch, press, or place anything on the LCD
II,
screen. These actions will damage the LCD screen.
I
Never attempt to service the TV yourself. Opening
I
and removing the covers may expose you to
I
dangerous voltage or other hazards. Failure to follow
;1;
this WARNING may result in death or serious injury.
Refer all servicing not specified in this manual to a
,II
Toshiba Authorized Service Center.
I
I
I
contain mercury Disposal may be regulated
due to environmental considerations. For
disposal or recycling information, contact
your local authorities or the Electronics
Industries Alliance (www.eiae.org).
Choosing a location for your LCD TV
To Display your LCD TV on the included
Pedestal Stand:
Observe the following safety precautions:
I) Read and Follow the pedestal assembly instructions
included with the pedestal.
CAUTION:
Before beginning pedestal assembly,
carefully lay the front of the LCD Panel face down
on a flat, cushioned surface such as a quilt or blanket.
Leave the bottom of the unit protruding over the edge
of the surface and assemble the pedestal as indicated
below.
Note: Extreme care should always be used
when attaching the pedestal stand to avoid
damage to the LCD panel.
2) Place the TV on a sturdy, level surface that can
support the weight of the TV.
3) Be sure to secure the TV to a wall, pillar. surface, or
other immovable structure. (1& item 23, page 4).
To Display your LCD TV using a Wall
Bracket:
If you decide to wall mount your LCD TV, always use
a UL listed wall bracket appropriate for the size and
weight of the LCD TV (1& page 2):
I)
CAUTION:
Two people are required for installation.
2) Unplug and remove any cables and/or other
component connectors from the rear of the TV.
3) Remove the screws of the VESA Mounting Pattern
show in the right diagram.
4) Follow the instructions provided with your
wall bracket. Before proceeding. make sure the
appropriate bracket(s) are attached to the wall and
the back of the TV as described in the instructions
provided with the wall bracket.
5) After attaching the appropriate bracket(s) to the wall
and the back of the TV, remove the pedestal stand
from the TV as described below.
(continued)
5