Yamaha mLAN Installation Manual page 17

Setting in the mLAN Auto
Connector
4
Set up the wordclock and specify the number
of audio channels (see below).
q
w
t
u
i
o
q Nickname
This field indicates the nickname of the connected 01X. To
change the nickname, refer to "Node Information" in the
mLAN Graphic Patchbay Manual.
w Model Name
This parameter enables you to select an mLAN device to
which you wish to make an mLAN connection in a multiple
mLAN device network.
e [Update] button
Clicking this button updates the information on the mLAN
devices connected to the mLAN network. Use this button
when you add an mLAN device to the network while mLAN
Auto Connector is running.
r [Identify] button
Clicking this button causes the 01X ACTIVE indicator to
flash for a few seconds.
t Sample Rate
This parameter enables you to specify the sampling fre-
quency (wordclock frequency).
y Wordclock Master radio buttons
These buttons enable you to specify the computer or 01X as
the wordclock master.
u PC → 01X
This parameter enables you to specify the number of chan-
nels of audio data input into the 01X from the computer's
audio output (mLAN driver's audio output). By selecting
"2ch" for "MONITOR 17-18," you can use the output to the
01X stereo monitor input. If the sampling frequency is set to
44.1 kHz or 48 kHz, ASIO channels 17 and 18 (mL17-18) are
connected to the 01X stereo monitor input. If the sampling
frequency is set to 88.2 kHz or 96 kHz, ASIO channels 9 and
10 (mL9-10) are connected to the 01X stereo monitor input.
i PC ← 01X
This parameter enables you to specify the number of chan-
nels of audio data input into the computer from the 01X.
!0 !1
o [Connect] button
Click this button to connect the 01X to the computer via
mLAN. When the connection is complete, the mLAN Auto
Connector window closes automatically.
!0 [Cancel] button
Clich this button to cancel the settings and close mLAN Auto
Connector.
!1 [Setup] button
e
r
Click this button to open the 01X Control Panel window,
which enables you to set the wordclock transition speed.
y
NOTE
• To listen to the sound input to the 01X monitor section, use the
[MONITOR A/B] button (refer to the 01X owner's manual).
• If you change the Sample Rate to 96kHz when LAYER of the
01X is set to 17-24 (mLAN), LAYER 1-8 will be called up
and channel 1 will automatically be selected.
5
Click [Connect]. If the connections have been
made properly, the mLAN Auto Connector
completes operation and mLAN data commu-
nication starts.
NOTE
• If for some reason connection fails, right- click the mLAN Driver
icon in the task bar to restart the mLAN Auto Connector and click
[Connect] again. You need not restart your computer.
mLAN Driver/mLAN Tools Installation Guide
17