Integrated Peripherals - Gigabyte GA-8I945GMBX User Manual

2-3

Integrated Peripherals

On-Chip Primary PCI IDE
SATA RAID/AHCI Mode
x On-Chip SATA Mode
x PATA IDE Set to
SATA Port 0/2 Set to
SATA Port 1/3 Set to
USB Controller
USB 2.0 Controller
USB Keyboard Support
USB Mouse Support
Azalia Codec
Onboard H/W 1394
Onboard H/W LAN
Onboard LAN Boot ROM
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
: Move Enter: Select
F5: Previous Values
On-Chip Primary PCI IDE
Enabled
Disabled
SATA RAID / AHCI Mode
RAID
AHCI
Disabled
On-Chip SATA Mode
Disabled
Auto
Combined
Enhanced
Non-Combined
PATA IDE Set to
Ch.0 Master/Slave Set PATA IDE to Ch. 0 Master/Slave. (Default value)
Ch.1 Master/Slave Set PATA IDE to Ch. 1 Master/Slave.
SATA Port 0/2 Set to
This value will auto make by the setting "On-Chip SATA Mode" and "PATA IDE Set to".
If PATA IDE were set to Ch. 1 Master/Slave, this function will auto set to Ch. 0 Master/Slave.
GA-8I945GMBX Motherboard
CMOS Setup Utility-Copyright (C) 1984-2005 Award Software
Integrated Peripherals
[Enabled]
[RAID]
Auto
Ch.0 Master/Slave
Ch.2 Master/Slave
Ch.3 Master/Slave
[Enabled]
[Enabled]
[Disabled]
[Disabled]
[Auto]
[Enabled]
[Enabled]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
3
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Enable onboard 1st channel IDE port. (Default value)
Disable onboard 1st channel IDE port.
Set the onboard SATA controller to RAID mode. (Default value)
Set the onboard SATA controller to AHCI mode. Advanced Host Controller
Interface (AHCI) is an interface specification that allows the storage driver to
enable advanced Serial ATA features such as Native Command Queuing and
hot plug. For more details about AHCI, please visit Intel's website.
Set the onboard SATA controller to IDE mode.
Disable this function.
BIOS will auto detect. (Default value)
Set On-Chip SATA mode to Combined, you can use up to 4 HDDs on the
motherboard; 2 for SATA and the other for PATA IDE.
Set On-Chip SATA mode to Enhanced, the motherboard allows up to 6 HDDs to
use.
Set On-Chip SATA mode to Non-Combined, SATA will be simulated to PATA
mode.
- 36 -
Item Help
Menu Level
F10: Save ESC: Exit
F7: Optimized Defaults
F1: General Help