Initializing A Hard Disk - Xante Accel-a-Writer 812 Manual

Caution: You need to assign an identification number to your hard
disk. Do not turn on the printer or any attached hard disk
until the disk has been assigned a number. See your
SCSI disk documentation for details on assigning this
number.
To connect the hard disk to your printer, use the following
procedure.
Caution: DO NOT confuse the serial and SCSI interface ports
when connecting cables. This will cause permanent
printer damage which is not covered under the warranty.
The printer has a 9-pin serial port that is labeled clearly.
1. Make sure the printer and the hard disk are turned off.
2. Connect the SCSI cable following the instructions included
with the hard disk.
3. Turn on the hard disk first and wait a few seconds for the hard
disk to "spin up."
4. Turn on the printer.
Once you have connected the hard disk to your printer, use the
procedure in the following section to initialize the hard disk.

Initializing a Hard Disk

External hard disks are identified by device numbers such as the
example in figure 2.24. Some disks may have a preassigned number
or you may need to assign it. See the hard disk documentation for
details.
2-36 Installationbb
Disk 0 Disk 1
Fig. 2.24 Hard Disk Device Numbers
_________________________________________
Disk 2 Disk 3 Disk 4 Disk 5