Xante Accel-a-Writer 812 Manual page 33

Hide thumbs Also See for Accel-a-Writer 812:

Table of Contents

If the transceiver box has a single male BNC connector,

either plug it into an existing Ethernet drop or use a "T"

connector (fig. 2.23). Follow the directions included

with the transceiver.

Note: Make sure to place a terminator in the open

10Base2 Terminated T Connection

Termination Resistor

Fig. 2.23 Connecting to a single BNC Connector

If the transceiver box has dual male BNC connectors,

first check the documentation to see if the unit is

self-terminating. Then, follow the instructions included

with the transceiver to attach one end of the coaxial

cable to the box.

Note: You can plug the coaxial cable into either one of

Plug the free end of the coaxial cable into the network.

Turn on the printer.

Now that your Macintosh and printer are connected, you may need to

set the zone name. For details, see the next section.

__________________________________________ Installation 2-33

connector if this is an end node on the network

(fig. 2.23).

Coaxial Cable

the male connectors; however, make sure that if

this is an end-node on the network and the unit

is not self-terminating, that you place a

terminator in the open socket on the box.

10Base2 Inline T Connection

Coaxial Cable

Table of Contents