SimpleTech STI-FAX/14.4V User Manual page 28

Communicator
AT Command prefix used to begin almost all commands.
Commands preceded by AT and followed by <Enter>:
D Dial the following number using the default or previous
method (tone or pulse).
Dial the following number using tones.
DT
Dial the following number using pulses.
DP
DS=n Dial stored number n.
W Wait for dial tone before dialing.
H Hang up the phone.
O Go on-line (switch from command mode to data mode).
Used to resume interrupted communications when the
remote modem is still on-line.
Sr? Read S-register r.
Sr=n Write value n to S-register r.
Zn Reset and recall saved profile n.
&Fn Recall factory configuration n.
&V Display current configuration and stored profiles.
&Wn Save current configuration as profile n.
&Zn=x Save x as stored telephone number n.
Command not preceded by AT and not followed by <Enter>:
A/ Repeat the previous command.
Page 28
Table 4-1. AT Command Summary