Battery Installation - GE PNRQ21RBN Owners And Installation Manual

OPTIONAL ONE-PERSON
FAUCET TUBING INSTALLATION
1. From under the sink, gather the 1/4" drain line
(black), 3/8" drain line (black) and 3/8" outlet
tube (blue banded) in one hand with the drain
tubes the same length and the outlet tube offset
approximately 6 inches.
2. Wrap a rubber band around all 3 tubes.
3. Insert a typical No. 2 pencil through the rubber
band location.
4. Rotate the pencil down until it is in line with
the tubing and push up through the mounting
hole. Release the grip on the pencil and the
tubes will remain in position for easier faucet
connection.
POWER CORD INSTALLATION
Connect power cord from
faucet to union outlet
from the Reverse Osmosis
Assembly.
NOTE: If extension cord
is required for a remote
location, this extension
phone cable must be 6 conductor wire and connectors;
typical 4 conductor will not work.
Installation Instructions
15
1. Remove the lens cover from the faucet base.
Grip it from both sides and pull forward.
2. Install one CR2032 3V battery with the
battery tray completely back into the base.
Faucet base
Lens cover
3. Each light will illuminate in sequence twice.
The OK (green) light or Filter (amber) light may
stay on for a few extra seconds. If you want to
reinitiate the start-up sequence, remove the
battery for 90 seconds so the electronics can
fully reset; then put the battery back in.
4. The OK (green) light will normally flash one time
per second when dispensing water. If the system
needs service, the Filter or R.O. (amber) lights will
flash one time per second while dispensing and
will randomly flash when not in use.
NOTE: For lights to change between OK and
R.O., the system must detect a change in the
filtering process for 25 consecutive seconds.
For example, if the system was showing that
service was needed, it will take 25 seconds of
consecutive filtering for the system to confirm
the correct service changes were made.
FOR FILTER CHANGE: Replace the battery
when changing the filter. Remove the used
battery and wait 90 seconds before installing
the new battery to ensure the proper
electronics are reset for the next 6 months.
Battery "+" side up