Sony HMZ-T2 Reference Manual page 32

Symptom
Video is not shown in 3D
3D display is not activated
automatically
32
Cause/Action
p If the same image is displayed side by side or on top and bottom,
the 3D display format setting may be incorrect. Try changing the
"3D Display" setting in "3D Settings" (page 21).
p 3D perception varies by viewer.
p If the "3D Settings" menu is displayed but images are not shown
in 3D, try restarting the connected equipment used for 3D
playback.
p The system does not support 2D to 3D conversion (simulated
3D).
p Viewing anaglyphic images in 3D requires anaglyphic glasses
(with red and blue lenses, for example).
p Also check the settings of playback equipment connected to the
processor unit.
p When the PlayStation
the video and audio output settings on the PS3™ do not match
those of this system or the cable and TV in use, there may be no
3D video output. If such symptoms occur, turn off the PS3™,
and then turn it on again by pressing its power button for at least
5 seconds until you hear a beep sound twice. The video and audio
output settings will automatically be reset to the standard
settings.
p If there is no 3D video output when this system is used with
playback equipment other than the PlayStation
momentarily stop playback, and then resume playback. If the
issue persists, try restarting the playback equipment.
p Make sure the "Auto 3D" setting in "3D Settings" is set to "On"
(page 22).
p 3D content without a 3D format identification signal is not
automatically displayed in 3D. Try changing the "3D Display"
setting in "3D Settings" to "Side-by-Side" or "Over-Under"
(page 21).
3 (PS3™) is used with this system and if
®
3 (PS3™),
®