Computer Image Adjustment ("Fine Sync" Menu); Adjusting The Computer Image; Special Modes Setting; Auto Sync (Auto Sync Adjustment) - Eiki EIP-1600T Owner's Manual

Computer Image Adjustment
("Fine Sync" menu)
Fine Sync
Clock
Phase
H-Pos
V-Pos
Reset
Special Modes
Auto Sync
Cur. sig. freq : H 33.8 kHz / V 60 Hz
1 Adjusting the
1 1 1 1
Computer Image
Use the Fine Sync function in case of irregulari-
ties such as vertical stripes or flickering in por-
tions of the screen.
Selectable items
Clock Adjusts vertical noise.
Phase Adjusts horizontal noise (similar
to tracking on your VCR).
H-Pos Centers the on-screen image by
moving it to the left or right.
V-Pos Centers the on-screen image by
moving it up or down.
Note
• You can automatically adjust the computer
image by setting "Auto Sync" in the "Fine
Sync" menu to "On" or pressing f AUTO
SYNC on the remote control.
• "Clock", "Phase", "H-Pos" and "V-Pos" can-
not be adjusted when INPUT 6 is selected.
• The adjustable area of each item may be
changed according to the input signal.
• To reset all adjustment items, select "Reset"
and press i ENTER.
46
EIP-1600T_EN_j
INPUT 5
0
0
Ordinarily, the type of input signal is detected
0
and the correct resolution mode is automatically
0
selected. However, for some signals, the opti-
mal resolution mode in "Special Modes" in the
1080I
On
"Fine Sync" menu may need to be selected to
match the computer display mode.
Description
This function allows you to check the current in-
put signal information.
46
Menu operation n Page 41

2 Special Modes Setting

2 2
2 2
Note
• Avoid displaying computer patterns which
repeat every other line (horizontal stripes).
(Flickering may occur, making the image hard
to see.)
• Information on the currently selected input sig-
nal can be confirmed in item 4.
3 Auto Sync (Auto Sync
3 3
3 3
Adjustment)
Selectable items
On Auto Sync adjustment will
occur when the projector is
turned on or when the input
signals are switched, when
connected to a computer.
Auto Sync adjustment is not
Off
automatically performed.
Note
• Auto Sync adjustment is also performed by
pressing f AUTO SYNC on the remote con-
trol.
• The Auto Sync adjustment may take some time
to complete, depending on the image of the
computer connected to the projector.
• When the optimum image cannot be achieved
with Auto Sync adjustment, use manual ad-
justments.
4 Checking the Input
4 4 4 4
Signal
06.1.24, 1:07 PM
Description