Mounting Tools And Equipment; Unpacking And Inspection - Cisco VG202 Hardware Installation Manual

Mounting Tools and Equipment

Task
Installation site prepower check completed
Required tools available
Additional equipment available
Cisco VG received
Quick start guide received
Regulatory compliance and safety information received
Information packet, warranty card, and Cisco.com card received
Software version verified
Rack, desktop, or wall-mounting of chassis completed
Initial electrical connections established
ASCII terminal attached to console port
Modem attached to console port (for remote configuration)
Signal distance limits verified
Startup sequence steps completed
Initial operation verified

Mounting Tools and Equipment

Obtain the following tools and parts to install Cisco VG202 and Cisco VG204 voice gateways:
•
•
In addition, you might need the following external equipment:
•
•
•
•

Unpacking and Inspection

Do not unpack the Cisco VG202 or Cisco VG204 voice gateway until you are ready to install the
equipment. If the installation site is not ready, keep the chassis in its shipping container to prevent
accidental damage.
The Cisco VG202 or Cisco VG204 voice gateway, cables, and any optional equipment that you ordered
might be shipped in more than one container. When you unpack each shipping container, check the
packing list to ensure that you received all the following items:
•
Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide
3-4
Screws and anchors for wall-mounting
Eight wood screws or other fasteners, for installing the chassis on a wall. An additional starter
–
screw can be used to facilitate wall-mounting.
ESD-preventive wrist strap
Console terminal or personal computer with terminal emulation software
PC running terminal emulation software for administrative access
Modem for remote access
Analog voice RJ-11 cable
Cisco VG202 or Cisco VG204 voice gateway
Chapter 3 Installing Cisco VG202 and Cisco VG204 Voice Gateways
Verified by Date
OL-15959-01