Cisco UC560-FXO-K9 Quick Start Manual page 18

Connecting to the UC 560
This section describes how to connect your PC to the UC 560 and how to
use CCA to connect to the UC 560.
Before you connect your PC, do the following:
• Disable all network interface Cards (NICs) that are not directly
connected to the UC 560.
• Turn off any third-party FTP or TFTP services.
• Temporarily disable any software firewalls running on the PC.
To connect to the UC 560:
Connect an Ethernet cable to one of the PC/EXP port the front panel
S 1
TEP
of the UC 560. Connect the other end of the cable to the Ethernet
port on your PC.
Verify that the PC is set to use the Dynamic Host Configuration
Protocol (DHCP) to obtain its networking parameters (such as IP
Address, Subnet Mask, Default Gateway, DNS Server, and so forth).
From CCA, open the Connect window and click Add a New Site.
S 2
TEP
This is the preferred way to connect to a Cisco Smart Business
Communications System (SBCS).
Enter the name and description for the new customer site.
S 3
TEP
From the Discover Devices drop-down menu, select Using a
S 4
TEP
Starting IP address.
16 Cisco Unified Communications 500 Series Model UC 560 Quick Start Guide
UC 560
PC/EXP port
Cisco
Configuration
Assistant