Cluster Storage - Dell PowerEdge FE600W Hardware Installation And Troubleshooting Manual

Cluster Storage

Table 1-2 lists supported storage systems and the configuration requirements
for the cluster nodes and stand-alone systems connected to the storage
systems.
Table 1-2. Cluster Storage Requirements
Hardware Components Requirement
Supported storage
systems
Cluster nodes
Multiple clusters and
stand-alone systems
Table 1-3 lists hardware requirements for the storage processor enclosures (SPE),
disk array enclosures (DAE), and standby power supplies (SPS).
Table 1-3. Dell|EMC Storage System Requirements
Processor Minimum Storage
Enclosure
CX3-10c SPE One DAE3P-OS with
at least five and up to
15 hard drives
CX3-20c SPE One DAE3P-OS with
at least five and up to
15 hard drives
CX3-20f SPE One DAE3P-OS with
at least five and up to
15 hard drives
CX3-40c SPE One DAE3P-OS with
at least five and up to
15 hard drives
10
Introduction
One to four supported Dell|EMC storage systems. See
Table 1-3 for specific storage system requirements.
All nodes must be directly attached to a single storage
system or attached to one or more storage systems
through a SAN.
Can share one or more supported storage systems using
optional software that is available for your storage system.
See "Installing and Configuring the Shared Storage
System" on page 45.
Possible Storage
Expansion
Up to three DAE with a
maximum of 15 hard
drives each
Up to seven DAE with a
maximum of 15 hard
drives each
Up to seven DAE with a
maximum of 15 hard
drives each
Up to 15 DAE with a
maximum of 15 hard
drives each
SPS
Two per SPE and
DAE3P-OS
Two per SPE and
DAE3P-OS
Two per SPE and
DAE3P-OS
Two per SPE and
DAE3P-OS