Connecting The Projector; Terminals Of The Projector - Eiki LC-SM2 Owner's Manual

CONNECTING THE PROJECTOR

Connect the composite video output
from the video equipment to the to the
Y/VIDEO or connect the
component video outputs.
, Pb/Cb and Pr/Cr jacks
(Refer to P12.)
This projector uses a micro
processor to control the unit.
Occasionally, the micro processor
may malfunction and need to be
reset. This can be done by pressing
the RESET button with a pen, which
restart the unit.
will shut down and
Connect an external audio
amplifier to this terminal.
(Refer to P12, 13.)
COMPUTER
INPUT
Terminal : HDB1 5-PIN
Connect the display output terminal of the computer to
COMPUTER INPUT terminal of this projector with the
VGA Cable (supplied). When connecting the
Macintosh computer, the MAC Adapter (not supplied)
is required
Connect the computer output
to this terminal.
(Refer to P13.)
TERMINAL
CONTROL PORT CONNECTOR
Terminal: DIN 8-PIN
Connect control port (PS/2, Serial or ADB port) on your
computer to this terminal with the Control Cable (the Control
Cable for PS/2 port
.
Connect the S-VIDEO output from
the video equipment to this
terminal. (Refer to P12.)
Connect the audio output from the
video equipment to this terminal.
(Refer to P12.)
Connect the audio output from the
computer to this terminal. (Refer to
P13.)
When controlling the computer with
the Remote Control of this
projector, connect the mouse port
of your personal computer to this
terminal. (Refer to P13.)
is supplied).
11