Table of Contents
Advertisement
Intel Desktop Boards D845GLLY and D845GLAD Product Guide
Installing and Removing a Processor
Instructions on how to install the processor to the Intel desktop board are given below.
Installing a Processor
CAUTION
Before installing or removing the processor, make sure that AC power has been removed by
unplugging the power cord from the computer; the standby power LED should not be lit
(see Figure 2 on page 16). Failure to do so could damage the processor and the Intel desktop
board.
To install a processor, follow these instructions:
1. Observe the precautions in "Before You Begin" on page 19.
2. Locate the processor socket and raise the socket lever completely.
3. Install the processor so that the corner with the triangle marking (A) is aligned with the corner
where the lever is attached to the socket (see Figure 5).
4. Lower the lever to its original position.
Installing the Processor Fan Heat Sink
Desktop Boards D845GLLY and D845GLAD have an integrated processor fan heat sink retention
mechanism (RM). For instructions on how to install the processor fan heat sink to the integrated
processor fan heat sink RM, refer to the boxed processor manual or the Intel World Wide Web
site at:
http://support.intel.com/support/processors/pentium4/intnotes478.htm
22
A
Figure 5. Installing a Processor
OM12078
Advertisement
Table of Contents
