Connecting The Processor Fan Heat Sink Cable; Removing A Processor; Installing And Removing Memory; Connecting The Processor Fan Heat Sink Cable To The Processor Fan Connector - Intel BOXD845GLLY - 845gl Pga478 Max-2GB Sdr Matx4pci Vid Snd Ata100 400mhz Product Manual

Connecting the Processor Fan Heat Sink Cable

Connect the processor fan heat sink cable to the processor fan connector (see Figure 6).
Figure 6. Connecting the Processor Fan Heat Sink Cable to the Processor Fan Connector

Removing a Processor

For instruction on how to remove the processor fan heat sink, refer to the processor installation
manual or the Intel World Wide Web site at:
http://support.intel.com/support/processors/pentium4/intnotes478.htm

Installing and Removing Memory

CAUTION
To be fully compliant with all applicable Intel SDRAM memory specifications, the boards require
DIMMs that support the Serial Presence Detect (SPD) data structure.
You can access the PC Serial Presence Detect Specification at:
http://www.intel.com/technology/memory/pcsdram/spec/
✏
NOTE
Remove the PCI bus connector 1 card before installing or upgrading memory to avoid interference
with the memory retention mechanism.
Desktop Boards D845GLLY and D845GLAD have two DIMM sockets arranged as banks 0 and 1,
as shown in Figure 7. If installing a single DIMM, install it in bank 0.
Refer to the Main Memory heading on page 11 for memory requirements.
Installing and Replacing Desktop Board Components
OM13684
23