Table of Contents
Advertisement
3.
Serial ATA connectors
(7-pin SATA1, SATA2, SATA3, SATA4, SATA5, SATA6)
Supported by the NVIDIA
connectors are for the Serial ATA signal cables for Serial ATA hard
disk drives that allows up to 3Gb/s of data transfer rate.
If you installed Serial ATA hard disk drives, you can create a RAID 0,
RAID 1, RAID 10, RAID 5, or JBOD configuration. Refer to Chapter 5
for details on how to set up the RAID configurations.
These connectors are set to SATA by default. In SATA mode, you can
connect Serial ATA boot or data hard disk drives to these connectors.
If you intent to create a Serial ATA RAID set using these connectors,
enable the RAID function of each port from the nVidia RAID Setup
sub-menu item in the BIOS. See section '4.3.5 IDE Configuration" on
page 4-16 for details.
KFN32-DL SLI SATA Connectors
The actual data transfer rate depends on the speed of Serial ATA hard
disks installed.
2-28
MCP55 Professional chipset, these
®
KFN32-D SLI
SATA2
SATA4
SATA1
SATA3
Chapter 2: Hardware information
SATA6
SATA5
Advertisement
Table of Contents
