Browsing The Map Display - Nextar Q4-01 Hardware Instruction Manual

Note that not all map display modes are supported in all zoom levels. The map can
display 3D at scales below 500 ft (Community zoom level). If the map display mode is
3D, the map switches from 3D to 2D mode when you zoom out to 500 ft. The program
will not allow you to change the map display mode to 3D at the 500 ft scale and higher.
The map display mode will automatically return to 3D mode once you zoom in to a scale
below 500 ft.
Similarly, if the map display mode is Heading Up, the display will automatically switch to
North Up mode when you zoom out to the 100 mile scale (State zoom level) or higher.
The map display mode will automatically return to Heading Up mode once you zoom in
to a scale below 100 miles. The program will not allow you to change the map display
mode to Heading Up at the 100 mile scale or higher.
In addition to using the Map Display Mode button on the map to change the display
mode, you can also use the Settings screen to set the default (startup) map display
mode. For more information, see

Browsing the Map Display

Browsing the map involves scrolling (i.e., moving) the map in the window. This feature is
useful to find a location or preview a route. To enter Browse mode, tap on the map
display. To scroll the map, tap and drag. (See below.)
Tap on the map
display to enter
Browse mode.
Tap-and-drag to
scroll the map.
Indicator in upper
right shows distance
from current position.
In Browse mode, the Browse Mode indicator in the upper right corner shows the
distance from your current position. When available, tap the "i" icon in the lower right to
view information about the selected location. In Browse mode, the menu command
buttons, including the GO TO button, will appear within a few seconds after you stop
scrolling. To calculate a route to the point indicated by the cursor, tap MENU > ROUTE
TO HERE. To exit Browse Mode, tap the 'X' button located in the upper right corner of
the display.
Configuring Map Display Settings
Tap on the map to enter browse mode
15
Tap "X" to exit
Browse mode.
Browse Mode
indicator shows
distance from
current position to
cursor position.