Step 14-Level Dishwasher - GE PDW7900P - Profile: Full Console Dishwasher Installation Instructions Manual

Installation Instructions
h_¸
STEP 12-INSTALL SIDE-MOUNT
BRACKETS (included with
some models)
Skip this step if underside of countertop is wood or
wood-like materia!,
- Install side-mount brackets if underside of countertop is :
granite or similar material that will not accept wood screws,
, Locate the side mount bracket kit set aside in Step I if it was
provided with this model. Otherwise, see Note below.
Note: The brackets are available for purchase when
needed for models not factory equipped with the side mount
kit. Order part GPF65 from gour authorized GE Appliance
Dealer.
• Fasten the left-hand bracket to the left side
of the dishwasher frame. Fasten the
right-hand bracket to the right side of the
dishwasher frame, using the #8 pan-head
screws inctuded with the kit. Refer to
Step 15, Figure U for orientation
and placement.
Side-Mounting
Brackets on
some models
STEP 13-PUSH DISHWASHER INTO
FINAL POSITION
Tip: Check tub insulation blanket, if equipped. It should be
positioned so it is not "bunched up" or interfering with door
springs. Check by opening and closing door.
o Push dishwasher into the cabinet. The edges of the
dishwasher door should be behind the cabinet frame and
evenlg atigned with the front face of cabinet doors.
Tip: Avoid unnecessurg service charges. Carefullg open and
close the door to ensure the door panel is not catching or
rubbing on the cabinet frame.
I
f
J
Door
Fits and
Swings
Back
Behind
Cabinet
Frame
Correct
Alignment
Alignment
Figure Q
STEP 14-LEVEL DISHWASHER
IMPORTANT- oishwosher must beIevel forproper
dish rack operation and wash performance.
• Place level on door and lower rock track as shown. Check to
make sure that the dishwasher is Jevet left to right and front
to back,
Ch ck
t°-Ba____ift_ t
Figure R
° Level the dishwasher bg adjusting the four leveling legs
individuatlg. Refer to Figure S below.
• If adjustment to the right rear leveling leg is required, loosen
junction bo× bracket screw {through the access hole} and
rotate bracket clockwise. Be sure to tighten screw when
leveling is completed.
Tip: Pull lower rock out, about holfwag. Check to be sure the
rack does not roll forward or back into dishwasher. If the rock
rolls in either direction, the dishwasher must be leveled again.
• If door hits tub, the dishwasher is not installed correctly.
Adjust leveling legs to align door to tub.
""" J Loosen junctiOn:box
...... --. -_- ' bracket screw and
/- \.
,/ ", , rotate bracket outof
__ thewagtoaccessthe
(_I " right rear leveling leg.
Tighten screw when
' leveling operation is
to Adjust ...... completed.
FigureS
8