GE PDW7900P - Profile: Full Console Dishwasher Installation Instructions Manual page 10

Installation instructions
STEP 17-CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES. ....
The motded end of the drain hose will fit 5/8" through 1" :
diameter inlet ports on the air gap, waste tee or disposer.
, Determine size of inlet port
• Cut drain hose connector on the marked line, if required, to fit
the inlet port.
Cutting Line
#
IMPORTANT: Do not cut corrugated portion of hose
Figure X
• If a longer drain hose is required and gou did not purchase
drain hose GPFIOL, odd up to 42" length for a total of 120"
110feet} to timefactorg installed hose. Use 5/8" or 7/8" inside
diameter hose and o coupler to connect the two hose ends.
Secure the connection with hose clamps.
Hose Clamp
Figure Y
Hose Clamp
• Secure the drain hose to the air gap, waste tee or disposer
with c!omps.
Note: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEET
FOR PROPERDRAIN OPERATION,
DRAIN LINE INSTALLATION
° Connect drain line to air gap, waste tee or disposer using the"
previously determined method.
Method I - Air gap with waste tee or disposer
Waste Tee Installation
Figure Z
Disposer Installation
Method 2 - Built-in "High drain loop" with waste tee or
disposer
Fasten to underside
of cauntertop
-- :-- .... k"" ?......................
]Z'
Min.
l tr--
I r
Fasten to underside
of counte_op
............. . .... ! ......
Waste Tee Instatfatian
Figure AA
Disposer Installation
I M PO RTANT- When
c onnecting
drain line to
disposer, check to be sure that the drain f==7=
plug has been removed. DISHWASHER WILL L__ 4--Remove
Drain
NOT DRAIN IF PLUG IS LEFT I I Plug
iN PLACE.
CCT
Tip: Avoid unnecessarg service coil charges. Prior to
connecting drain hose be sure excess hose is not trapped,
kinked or crushed by the dishwasher. Pull excess hose through
the cabinet opening to prevent hose damage and pump out:
issues.
lo