Table of Contents
Advertisement
Chapter 2 Wireless LAN Access Point
1. Locate an optimum location for the Wireless LAN Access Point.
The best location for your Wireless LAN Access Point is usually at the center of
your wireless network, with line of sight to all of your mobile stations.
2. Connect the Wireless LAN Access Point to your 10/100Mbps network.
Connect one end of standard UTP cable to the Wireless LAN Access Point's
10/100Mbps RJ-45 connector and connect the other end of the cable to a switch or
a hub. The Wireless LAN Access Point will then be connected to your
10/100Mbps Network.
3. For configuration purposes, connect the Wireless LAN Access Point to your
PC through the USB port.
If the USB port of your PC is working properly, your system should immediately
recognize the Access Point and attempt to install a driver for it. Make sure that the
Setup CD is inserted into your CD-ROM drive and then follow the instructions of
the setup program. Select Specify a location and type in the blank field D:\
Driver\Winxxx (where "D" specifies your CD-ROM) to install the driver
automatically. The driver supports Windows 98/98SE/Me/2000/XP operating
systems.
Note: Windows 2000 driver can also be used as Windows XP driver.
4. Connect the AC Power Adapter to the Wireless LAN Access Point's Power
Socket.
Only use the power adapter supplied with the Wireless LAN Access Point. Using
a different adapter may damage the product.
The Hardware Installation is complete.
Connection
Wireless LAN Access Point Connection
6
Advertisement
Table of Contents
