Configuring The Qos Settings - Cisco WRVS4400N - Small Business Wireless-N Gigabit Security Router Administration Manual
Wireless-n gigabit security router with vpn
Hide thumbs
Also See for WRVS4400N - Small Business Wireless-N Gigabit Security Router:
- Administration manual (233 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Setting Up and Configuring the WRVS4400N Wireless-N Router
Configuring the QoS Settings
STEP 3
Configuring the QoS Settings
Cisco WRVS4400N Wireless-N Gigabit Security Router with VPN Administration Guide
•
L2TP Passthrough—Layer 2 Tunneling Protocol is the similar to PPP but
allows Layer 2 and the PPP session to terminate at different servers or
locations. L2TP Passthrough is enabled by default. To disable L2TP
Passthrough, select Disabled.
Click Save.
This section describes how to configure the QoS settings of the router:
•
Managing Bandwidth on page 119
•
Configuring QoS on page 121
•
Configuring DSCP on page 122
QoS allows you to perform bandwidth management, by either rate control or
priority. You can also configure the QoS Trust Mode and DSCP settings.
5
118
Advertisement
Table of Contents
