Quick Start Function - Canon 4316B001 Instruction Manual

2 Touch the zoom controls to operate
the zoom.
Touch anywhere within the Q area to
zoom out or anywhere within the P area
to zoom in. Touch closer to the center for
a slow zoom; touch closer to the e/d
icons for faster zooms.
3 Touch [a] to hide the zoom controls.
NOTES
• Keep at least 1 m away from the subject. At full wide angle, you can
focus on a subject as close as 1 cm.
• In or
[Zoom Speed] to one of three constant speeds (3 is the fastest, 1 the
slowest).
• When [Zoom Speed] is set to [I Variable]:
- When you use the P and Q buttons on the wireless controller, the
zoom speed will be constant at [J Speed 3].
- The zoom speed will be faster in record pause mode than when
actually recording, except when pre-recording (0 63) is activated.

Quick Start Function

When you close the LCD panel with the camcorder on, the camcorder
enters the standby mode. In standby mode the camcorder consumes
only about 1/3 the power used when recording, saving energy when
you are using a battery pack. Additionally, when you open the LCD
panel or pull out the viewfinder (b only), the camcorder is ready to
start recording in approximately 1 second*, allowing you to record the
subject right away.
* The actual time required varies depending on the shooting conditions.
Operating modes:
1 With the camcorder on and in a recording mode, close the LCD
panel.
A beep will sound and the green ON/OFF (CHG) indicator will change
to orange to indicate the camcorder entered standby mode.
44
Dual Shot Mode
mode, you can also set 7/8
8