Table of Contents
Advertisement
• Approximately 30 seconds before the camcorder shuts off, [Auto power
off] will appear.
• In standby mode, the camcorder will shut off after the time selected for
the [Quick Start] setting.
[Quick Start]:
Select whether to activate the Quick Start function (
when you close the LCD panel in a recording mode and the length of time
after which the camcorder will end the standby mode and shut off auto-
matically.
[Control for HDMI]:
trol) function. When you connect the camcorder to an HDTV compatible
with HDMI-CEC using an HDMI cable, you can control the camcorder's
playback using the remote control of the TV.
• If set to [
On], when the camcorder is connected to a compatible
HDTV using an HDMI cable, the video input on the TV will automatically
be set to the camcorder's video input. Then, you can use the up/down/
left/right buttons and the OK or SET button on the TV's remote control
to play back your recordings.
• Depending on the TV set, additional settings may be required on the TV
itself to activate the HDMI-CEC function. Refer to the TV's instruction
manual.
• Correct operation of the HDMI-CEC function cannot be guaranteed
even when connecting the camcorder to compatible TV sets. If you
cannot use the remote control of the TV, set [Control for HDMI] to
[
Off] and operate the camcorder directly or use the camcorder's
wireless controller.
• The remote control of the TV can only be used to play back movies or
photos (
or
TV while it is set to a recording mode, depending on the TV used, turn-
ing off the TV will automatically turn off the camcorder even if it is
recording at the time.
[Photo Numbering]:
new memory card. Photos are automatically assigned consecutive num-
bers from 0101 to 9900, and stored in folders containing up to 100 pho-
tos. Folders are numbered from 101 to 998.
[
Reset]: Photo numbers will restart from 101-0101 every time you
insert a new memory card.
[
Continuous]: Photo numbers will continue from the number following
that of the last photo recorded with the camcorder.
Activates the HDMI-CEC (Consumer Electronics Con-
mode only). If the camcorder is connected to the
Select the photo numbering method to be used on a
Additional Information
43)
145
Advertisement
Table of Contents
