Error Messages - Yamaha Card Filer Manual

Error Messages

"The selected MIDI device is in use. Quit any applications currently using
the device."
This message is displayed when the Card Filer starts up and the MIDI driver is currently being used
by another application. Click [OK], quit any applications that are using the MIDI driver, and start the
Card Filer again.
"Cannot find the MIDI device. Confirm the MIDI device settings."
Refer to the README file included with the MIDI driver (YAMAHA CBX Driver), install the MIDI
driver, and select the correct COM port, etc.
OMS is not installed.
Install the OMS software and make the correct set it up according to the section
(Page 6)."
"Data transfer failed. Confirm the current connections (HOST SELECT
switch and others)."
Confirm the following and try the operation again.
• Is the MIDI device properly connected to the computer?
If not, make the proper connections according to the instructions in the MIDI instrument's
Owner's Manual.
• Is the MIDI device switched ON?
If not, switch the power ON.
• Is the MIDI device's HOST SELECT switch set correctly?
Make the correct the setting according to the instructions in the MIDI instrument's Owner's
Manual.
• Is the device properly set up?
Refer to the README file included with the MIDI driver (YAMAHA CBX Driver), install the MIDI
driver, and select the correct MIDI driver.
• Set up OMS according to the section
"Data transfer is not possible in the current mode. Press the [EXIT]
button, etc., and designate a mode that allows data transfer"
"Failed to create "********.*** (File name)" The disk in the destination drive is full."
The file could not be saved to the disk because the disk is full.
"Specify up to 8 letters for the file name and up to 3 for the extension."
A folder name can consist of up to 8 characters. A file name can consist of up to 8 characters
plus a 3-character extension.
"OMS settings (Page 6)."
15
"OMS settings