Table of Contents
Advertisement
AUTO MODE (BUTTON CONTROL TYPE ONLY)
If you press AUTO MODE, the power is automatically set at
1200~1300 watt.
This mode reduces the suction power fluctuation which is caused by
the fluctuation of airflow quantity to the motor.
For example, when dust bag is full, the quantity of air to the motor will
be decreased and power will be down followingly. AUTO MODE, in
this case, increases the power automatically for sufficient suction.
If you want to go back to the normal control type, just press "+" or "-"
buttons.
Using Exbug Elimination System (DEPENDING ON MODEL)
It is best to use the Mite Killing cycle immediately after you have finished
your cleaning.
Ensure machine is plugged in and the power point is switched on.
Disconnect the hose from the cleaner by pressing in the two but-
tons on the hose end and lift the hose out.
Close the hose connection cover on the top of the cleaner until
tone is heard. Make sure that it is fully shut.
Switch the cleaner on and the cleaner will run.
The Mite Killer cycle will automatically stop when complete.
Unplug the cleaner, rewind the cord, open the hoses connection cover and re-connect the hose.
Your cleaner can be used immediately after the Mite Killer cycle stop or by interrupting the cycle. To do
this,switch cleaner off,open the hose connection cover and re-connect the hose.
EN-6
Open the tool storage cover upwards.
CREVICE
Crevice tool for radiators, crevices,
Dusting brush for furniture,
corners, between cushions.
shelves, books, etc.
Located in the top rear side of the vacuum cleaner,there is
a nozzle support that can be used to park the nozzle during
pauses in cleaning
TRANSPORTING AND STORING THE VACUUM CLEANER
For easy storage and transportation, this vacuum cleaner has a
clip system built into body, which will keep the wand, hose and
nozzle in an upright position.
USING THE ACCESSORIES
DUSTING
UPHOLSTERY
Upholstery brush for cushions
and drapery.
PARK POSITION
EN-7
Advertisement
Table of Contents
