Dust Indicator; Replacing The Dustbag - Samsung VC-6814VN Operating Instructions Manual

ASSEMBLING THE VACUUM-CLEANER SO THAT IT IS READY FOR USE
1. Slide the free end of the extension wand into the nozzle tube.
2. Slide the narrow end of one extension wand into the other
extension wand.
3. Slide the extension wand into the handle end of the hose.
4. Slide the hose clamp into the suction inlet of the unit.
* Option Assemble the CYCLONIC FILTER with the handle
and extension wand(depending on model).
Ajusting the telescopic tubes (depending on model).
USAGE OF FLOOR NOZZLE
FOR RUG / FLOOR SELECTOR
Before use make sure that the position of the selector is in the right position for the type of surface to be
cleaned.
Select the carpet indicator
when cleaning carpets.
FOR UNIVERSAL BRUSH
Use the floor nozzle for all cleaning surfaces.
NOTE:
For optimum efficiency, clean floor brush with crevice tool.
*OPTION
*OPTION
EXTENDING : Holding narrow
side of the telescopic tube with a
hand, pull the hadle to the oppo-
site side of it with another hand.
SHORTENING : Push the handle
to the narrow side
of the tube, hoding
it with another
hand.
Select flat surface indicator
when cleaning the floors,
tiles, etc.
SUCTION POWER CONTROL
Your cleaner has variable electronic suction control to give you greater versatility.
Select the most suitable position according to cleaning needs.
The suction capacity can be regulated steplessly by moving the slide to the desired position.
Vacuum power can be adjusted to suit different situations using the power control.
MIN
MIN
A
You may continue cleaning until the dust indicator changes and displays red colour. This means the
dust bag is full and needs to be replaced.
If the indicator suddenly displays red and the cleaner loses suction power while in use, turn your cleaner
off and check whether the hose, pipe or nozzle is clogged.
When you check bag status by indicator, set motor power on maximum position.
NOTE :
Hose must be disconnected before changing bag.
Replace the dust bag as soon as it is full.
1. To open the dust cover of the dust bag compartment, lift the front of
cover upwards.
2. Remove the dust bag from the cleaner.
3. Dispose of the full bag. Insert the cardboard bag collar of the dust
bag as far as it can go on the suction inlet along the slide guide.
Position the dust bag so that no part of the bag is pinched.
4. Press the front of dust cover down lightly until it re-locks.
NOTE :
In the absence of a dust bag, the cover cannot be closed,
do not close forcibly.
(ONLY VARIABLE CONTROL TYPES)
REMOTE CONTROL TYPE
SLIDE THE PART "A" IN THE STOP POSITION
MAX
Vacuum cleaner switches off (stand by mode)
SLIDE THE PART "A" TOWARDS MAX
Suction capacity increases steplessly up to MAX.
MAX BODY CONTROL TYPE
MIN - For delicate fabrics, like curtains.
MAX - For hard floors and heavily soiled carpets.

DUST INDICATOR

REPLACING THE DUST BAG