Help Function
Display Screen Selection
This function allows you to
change the display screen in
�
the base set standby state
Toll Restriction
1
●
When the toll restriction is set,
cancelled,
disappears.
●
Even when the toll restriction is set, you can make a toll call with the base set. But,
when you start dialing 8 on the remote set, the unit beeps and then returns to the
standby state.
� Check
Setting the Dialing Mode
1
●
You can set the dialing mode either as rotary dialing or tone dialing.
●
When the rotary dialing is set,
the tone dialing is set,
� Check
When the dialing mode of the base set is set to the rotary dialing mode
●
Press
button while dialing with the base set or the remote set, and the dialing mode is
switched to the tone dialing mode.
40
�
�
2
3
is displayed on the screen and when it is
� Cancel the
� Set the toll
toll restriction
restriction
2
3
P
is displayed during the call and when
is displayed.
T
� Rotary Dialing
� Tone Dialing
Help Function
You can adjust the flash
time.
�
4
This function generates
warning tone when the
battery voltage of the
remote set drops below
the specification.
4
Adjusting the flash time
(In the standby state)
● The flash time is to 0.4 second as default.
�
�
�
: 0 . 1 sec
: 0 . 2 sec
: 0 . 3 sec
: 0 . 6 sec
: 0 . 7 sec
: 0 . 8 sec
Low Voltage Warning Function
When the battery
charging is insufficient
blinks and warning
tone is transmitted.
● Even though there was no low voltage warning in the standby state, the low voltage
warning may be generated if you make calls using the remote set as it consumes the
battery.
Press the button
�
corresponding to the
desired time.
: 0 . 4 sec
: 0 . 5 sec
: 0 . 9 sec
: 1 . 0 sec
Charge the remote
�
set immediagely.
41