Power Save Mode - Samsung WF10 Manual

SAMSUNG Computer WF10

Power save mode

Q
A
Q
A
Q
A
Q
A
Q
A
Communication
Q
A
82
SAMSUNG Computer WF10
Can I connect an USB device while in the power save mode.
When you connect an USB device in the power save mode, you may not
receive a normal display. An USB device must be connected while you are
in standard operation mode.
My USB device won't operate properly after leaving the power save
mode
Unplug and then plug in the USB device again.
My display is not normal after entering power save mode while in the
DOS window.
Press on the <Alt> and <Tab> keys simultaneously.
I can't run the ACPI (power management control) power save mode
after adding an expansion card or driver
Check whether the added card or driver support the ACPI function.
If the function is not supported, run start > Control Panel > Performance and
Maintenance > Power Options, and set the system standby mode on
'Never' in Power Schemes.
I cannot run the ACPI (power management control) power save mode
while using application programs or games
Check whether the application or game support the ACPI function.
If the function is not supported, run start > Control Panel > Performance
and Maintenance > Power Options, and set the system standby mode on
'Never' in Power Schemes.
I use an inter-office telephone, but I can't get a dial-tone.
If you are on a private switchboard (including key phone) system that
requires dialing "9" to get an outside connection, you must setup the
following command before use.
(Or add in the modem initialization command)
-Setup the ATX3 command before use.
-Additionally, if you need to dial "9" before making calls, you insert "9" after
the ATDT. (e.g.: ATDT9,3679-1433)