Table of Contents
Advertisement
SAMSUNG Computer WF10
1. Double-click on the ESS Canyon3D 2 Audio Properties (
2. Select the S/PDIF tab and make check the Enable S/PDIF Out item.
N N
N N
The digital output jack on the rear soundcard (S/PDIF-Coaxial)/Analog
(Center/Sub Woofer Speaker) may be setup to output digital or analog sounds.
The default setting is setup on digital sound (4 Speaker).
Follow the instructions below to change to analog setting.
1. Double-click on the ESS Canyon3D 2 Audio Properties (
2. Select the Speaker Setup tab, Select 5.1 Speakers to setup for analog sound.
30
SAMSUNG Computer WF10
Using the front digital sound output jack
o o
t t
e e
When using the 5.1 channel speakers, use the volume control on the speakers
o o
t t
e e
to adjust the volume.
Setting up the rear digital sound output jack
(S/PDIF-Coaxial)/Analog(5.1 Speakers)
Taskbar.
(S/PDIF-Optical)
) icon on the Taskbar.
) on the
N N
o o
t t
e e
N N
o o
t t
e e
The Enable S/PDIF Out on the
S/PDIF tab must be enabled to out
put digital sound.
N N
o o
t t
e e
N N
o o
t t
e e
When using digital S/PDIF speakers,
you may use the S/PDIF-Optical port
in the front or S/PDIF-Coaxial in the
rear as they both serve the same
purpose.
Advertisement
Table of Contents
