Samsung WF10 Manual page 74

SAMSUNG Computer WF10
Q&A
The following is frequently asked questions regarding the use of your computer,
and their answers.
When turning your computer ON
Q
A
Q
A 1 Check if the Hard Drive signal cable and power cable are connected
A 2 Check if the BIOS Setup Utility recognizes the Hard Drive properly.
A 3 Check if the Hard Drive jumper setup is correct.
A 4 The Hard Drive operating system is damaged. Please reinstall Windows.
Q
A 4 The BIOS Setup Utility setup and system environment are not compatible.
78
SAMSUNG Computer WF10
I'm getting the 'Invalid system disk, Replace the disk, and then press
any key' message.
You have a general diskette in the floppy drive. Take the general diskette
out or replace with a booting diskette and press any key on the keyboard to
resume.
I'm getting the 'Operating system not found' message.
This message appears when there is an error in the Hard Drive connection
or BIOS Setup Utility. Please check these items.
properly.
The primary menu's primary IDE master category is setup for automatic
recognition.
Drive instruction booklet and setup the primary IDE master category.
(Refer to Chapter 4 Setting up your drive sequence)
I'm getting the 'Press <F1> to continue and <F2> to return to install'
message.
Reset to meet system environment.
1. Refer to Chapter 4 to run BIOS Setup Utility.
2. Press <F9> to enter Setup Confirmation.
Select <Yes> and press <Enter>.
If devices have been added, reset items relative to that driver.
3. Press <F10> to enter Setup Confirmation.
Select <Yes> and press <Enter> to restart.