Table of Contents
Advertisement
Inserting and removing a battery from the rear pocket
Figure 5. Adding and Removing a Battery from the Rear Pocket
1.
Insert the battery with the Motorola label facing forward. To do this, align
the sides of the battery with the charger rails.
2.
Make sure the metal contacts on the back of the battery are in contact with
the charging contacts.
3.
To remove the battery, pull it up and out of the Charger.
NOTE: If a battery is in the rear pocket, and the phone with a battery is
inserted into the front pocket, the battery in the front pocket will
charge to full capacity before the battery in the rear pocket is charged.
The LED for the rear pocket flashes yellow, indicating that its battery is
waiting to be charged.
NOTE: To remove the battery from the rear pocket, hold the base of the
charger and pull the battery up.
Desktop Charger Status
The Charger displays the battery's charge status. The indicator will show one of
the following:
solid red =1-30%; solid yellow =31-60%; flashing green =61-90%; solid green
=91-100%.
Desktop Charger Troubleshooting
If the battery is not charging and you see:
Flashing yellow indicator -
• The flashing yellow LED is used to indicate that the Charger's
pocket is in a wait state.
• If a battery is in the rear pocket, the rear pocket's LED continues to
flash yellow until the battery in the front pocket is more than 90%
charged (front pocket's LED is solid green). This is normal
operation.
• To protect your battery's life expectancy, the Charger does not rapid
charge a battery when its temperature is below 5
60
Insert
1
www.mot.com/iDEN
Remove
2
o
o
C (41
F) or above
Advertisement
Table of Contents
