Connections; Preparing The Remote Control Unit - Kenwood M-303USB Instruction Manual

Before applying power

Connections

Connecting the AM antenna
Set up the AM loop antenna, and then connect it to
AM ANT terminal on the back.
Place the antenna where AM broadcast can be
received.
For the FM antenna
Adjust the position of the FM antenna for the best
reception and fi x it.
Speakers connection
1
Connect the right speaker to terminal marked
"R", with the red wire to + and the black wire to
–.
2
Connect the left speaker to terminal marked "L",
with the red wire to + and the black wire to –.
Clip the stripped portion of the speaker wire as
shown.
⁄
• For optimal sound performance, it is recommended to use
the supplied speakers.
• Do not connect more than one speaker to any one pair of
+/– speaker terminals.
¤
CAUTION
Be sure to adhere to the following, or proper
ventilation will be blocked causing damage or
fi re hazard.
• Do not place any objects impairing heat radiation onto
the top of the unit.
• Leave some space around the unit (from the largest
outside dimension including projection) equal to or
greater than, shown below.
Top panel : 50 cm Back panel : 10 cm

Preparing the remote control unit

Operation
When the power cord is plugged in, standby
indicator is lit. The power turns ON by pressing
button on the remote control unit pointing at the
remote sensor. When the power comes on, press the
button you want to operate.
⁄
• The supplied battery may have shorter live than ordinary
battery due to use during operation checks.
• When the remote-controllable distance gets shorter than
before, replace the battery with a new one.
• Placing the remote sensor in direct sunlight, or in direct
light from a high frequency fl uorescent lamp may cause a
malfunction.
In such a case, change the location of the system installation
to prevent malfunction.
Loading batteries
Use two "AAA"/"R3"-size batteries.
1
Remove the cover.
2
Insert batteries.
3
Close the cover.
¤
CAUTION
For Main Plug : Mains plug is used as the disconnect
device. It shall remain readily, operable and should not be
obstructed during intended use.
5
EN