Virtual Modes - Kenwood KRF-V8090D Instruction Manual

Ambience effects
DSP mode
This mode can be selected when digital signals other than Dolby
Digital or DTS, or analog signal come in.
1 Pressing the DSP key or DSP MODE key will display the
current DSP MODE status.
2 Each press of the key will switch to the next status as shown
bellow:
1 Arena
: Arena mode.
2 Jazz Club
: Jazz Club mode.
3 Theater
: Theater mode.
4 Stadium
: Stadium mode.
5 Disco
: Disco mode.
• The DSP mode selection is displayed for approximately 3 seconds.
Switching the LISTEN mode to Stereo temporarily
Pressing the STEREO key changes the currently selected LISTEN mode
into Stereo. It will be changed back to the original LISTEN mode by
pressing the STEREO key again.
• If the power is turned off and turned back on, or the input selector is
switched to another and switched back, the LISTEN mode will be back to
the original one.
Notes
• Depending on the type of the signal or speaker setting, some listening
modes cannot be selected.
• When playback is started, the sound may be cut or interrupted before
the input source is confirmed as Dolby Digital or DTS.
• To enjoy Dolby Digital surround (as well as all the other listening
modes) from a single component, be sure to use a Dolby Digital
compatible source component.
36 EN

Virtual modes

The following modes allow you to enjoy astonishing ambience effect
even when you use only two speakers or listen through headphones.
• In the Dolby Virtual Speaker and Dolby Headphone modes, the desired
listen mode may be unable to be selected depending on the reproduced
signals.
DOLBY VIRTUAL
PHONES
How to set the Dolby Virtual Speaker mode
(when not using headphones):
Press the DOLBY VIRTUAL key for the following selections:
1 DOLBY VS WIDE : The virtual surround effect can be given added
expansion and spatial feeling.
(DOLBY VS indicator lights up)
2 DOLBY VS REF
: Standard setting.*
(DOLBY VS indicator lights up)
3 DOLBY VS OFF
: Cancel
(DOLBY VS indicator goes off)
* This mode can be selected only when the surround speaker setting
is OFF.
How to set the Dolby Headphone mode
(when using headphones):
Press the DOLBY VIRTUAL key for the following selections:
1 DOLBY H DH 1
: Monitor room in a studio with small amount
of reverberations.
(DOLBY H indicator lights up)
2 DOLBY H DH 2
: General listening with optimum amount of
reverberations.
(DOLBY H indicator lights up)
3 DOLBY H DH 3
: Wide space such as a movie theater.
(DOLBY H indicator lights up)
4 DOLBY H OFF
: Cancel
(DOLBY H indicator goes off)
• The Dolby Virtual Speaker mode will be available when the SPEAKERS
A is ON and SPEAKERS B is OFF.
• Dolby Virtual Speaker is effective for sampling frequencies of 32kHz,
44.1kHz and 48kHz. Dolby Headphone is effective for sampling fre-
quencies of 44.1kHz and 48kHz.
fi
DOLBY VIRTUAL