Getting The Most From Your Remote Control; Operating Other Components - Kenwood KRF-V6030 Quick Start Manual

Getting the most from your remote control

The remote control supplied with this receiver is also
capable of controlling components from a variety of manu-
facturers once you register the appropriate setup codes
into the remote control unit.
Refer to "Remote operation of other components" for de-
tails about the operations available for each component.
Low battery warning
Replace all four batteries with new ones when you notice a shortening
of the distance from which the remote control will operate. The remote
control is designed to retain setup codes in memory while you change
batteries.
Registering setup codes for other components
Numeric keys
1
Find the setup code of the component to be registered.
• Refer to the setup code lists to find the setup code for the component
to be registered.
Example: To register a DVD made by KENWOOD, you would enter
"805".
Input Component
(DVD) DVD player KENWOOD 804,805,808
2
Hold down the POWER key and press the numeric keys to
enter the setup code.
• Example: Press "805" to register a DVD player made by KENWOOD.
• If you push an invalid key, the remote will exit the setup mode.
3
Press the source POWER (TV, VCR/CDR, DVD) key for
more than 2 seconds, and check to see that the compo-
nent you want to control turns on.
If the component does not react, and there is more than one
setup code, enter another setup code and try again.
• 6, TUNING 1/¡, or MULTI CONTROL key(s) can also be used
instead of the POWER key.
• If the component is already on, pressing the source POWER keys will
turn it off.
POWER
Source
POWER
keys
RC4
Maker Code Key
DVD
4
Repeat steps 2 to 3 to register additional components
until all components have been registered.
Note
Although each setup code is designed to work with a number of different
models, certain codes may not work with some models. (Also, certain
codes may only operate some of the functions available on a given
model.)

Operating other components

This operation lets you operate the registered components.
KENWOOD audio components with system control turn on and off
automatically with the receiver via the system control connections.
RECEIVER
1
Use the input selector keys to select the component you
desire.
• Pressing the input selector keys also changes the input selector on
the receiver.
• When you operate your registered TV, VCR, CDR, or DVD
player, go to step 2.
• When you operate the CD player, Cassette deck, MD player, or
Tuner with system control connection, go to step 3.
2
Press the source POWER key.
3
Press the operation keys you desire.
• See "Remote operation of other components" for a list of keys
available with each component.
• To return to the receiver operation mode, press the RECEIVER key.
The remote control mode returns to the receiver operation mode
when you do not operate for more than 15 seconds.
Note
Be sure to point the remote control at the remote sensor on the receiver
when you want to operate KENWOOD components connected by
system control cords. Otherwise, point the remote control at the compo-
nent you want to operate.
3
POWER
Source
POWER
keys
RC6