Kenwood DX-7 Instruction Manual page 27

Cleaning
• Cleaning the cabinet
Clean the cabinet by wiping with a dry cloth. If an area is particularly dirty and cannot be cleaned
well with a dry cloth, wipe the area with a cloth dampened with water, then wipe dry with a
dry cloth. (Do not use benzene, thinner, or other chemicals.1
Always keep terminals and plugs clean.
• Cleaning the head
If the head becomes dirty or covered with dust, sound dropouts or noise may occur.
Also, if the head becomes clogged during playback, "Error" will appear on the display and the
sound will stop.
In such cases, clean the head with a commercially available OAT-use head cleaning tape.
• Do not inject oil into the unit. This will damage the unit.
If the head becomes worn after long use, it must be replaced. Contact your dealer for the replace-
ment (fee required!,
• "Error" may appear on the display if a wrinkled or damaged tape is used or if the head becomes
clogged. If this occurs, replace the tape or try cleaning the head with a cleaning tape.
• If this unit is subjected to a strong external disturbance (such as a shock or abnormal voltagel
or misoperation, the unit may stop responding to button operations or operate abnormally.
In such a case, disconnect the AC adaptor plug, wait about 30 seconds, reconnect the plug,
then retry the operation.
• Accessories
(1) Remote controller
(3) Digital connection Cord
(5) Digital-use adaptor plug
(2) AC adaptor
(4) Analog connection cord
(6) Plug adaptor (Except for USA, Ca'nada
and UK)
DX-7
27