First load a tape into the unit (see page 14).
Operation is possible with either the main unit or the remote controller.
Connect the unit (See page 11.)
Press the [REC] button.
When starting recording from the begin-
ning of the tape, the unit automatically cre-
ates a 5-second blank section and then
enters record-standby mode.
Press the [PLAY/REPEAT] button to start
You can also start recording by pressing
the [PAUSE] button.
To stop recording, refer to page 20.
Changing the [VOLUME] level during
recording has no effect on the recorded
If five seconds elapse after the [REC] but-
ton is pressed, the rotating head moves
away from the tape to protect the tape.
(The REC indicator blinks.)
A ST-ID is automatically recorded at the
start of each tune. (See page 23.)
When carrying out digital recording from
another DAT deck using a tape recorded
with ST-IDs and SKIP-IDs, the same sub-
codes are recorded on the new tape.