Preparing To Play Tracks - Kenwood DP-R6090 Instruction Manual

Preparing to Play Tracks

Preparation
• Turn the unit ON.
Loading/unloading discs
1
Load/unload a disc.
1
Open the tray.
2
Place/remove a disc.
Label side
Disc tray
3
When loading or unloading other discs
2
Close the tray.
ALL TEXT SEARCH
For most CD-TEXT discs, it is convenient to read the complete disc information into the CD player before playing the disc.
This allows text information such as TITLE SEARCH, TEXT DISPLAY, ALL INFO., and other messages to be displayed faster.
After loading all the discs, operate in stop mode.
REMOTE CONTROL UNIT
RC-P0601
÷ The information read into the CD player is cleared
when the tray is opened. Therefore, perform this
operation again if the tray was opened.
-ON –STANDBY
0
DISC SKIP
0
Remote control unit only
ALL TEXT
SEARCH
REMOTE CONTROL UNIT
RC-P0601
: Keys and control used in the operations described on this page.
÷ Do not touch the played side of disc.
÷ Loading two discs together will cause malfunctioning.
÷ Place the disc properly along the groove on the tray. (If the disc is not
placed horizontally, malfunction will result.)
÷ A single CD (8 cm disc) can also be played.
÷ Ordinary CD single (8 cm) disc adapters sold in audio stores cannot be
used with this unit.
÷ When loading/unloading a disc while the tray rotates, a malfunction
might occur. Load/unload the disc when the tray does not rotate.
DISC 1 DISC 2 DISC 3
All DISC indicators " " light regardless of how many discs are
present.
Search in progress or reading information
D I S C R A
«
D 1 : CD
÷ Repeat the above procedure so that the complete disc information is
read into the CD player.
÷ In the case of a non-CD-TEXT disc, the "D1 : NO CD TEXT" display will
appear for approx. 3 seconds.
DP-R7090/R6090 (En)
DISC 4 DISC 5
Blinks.
E D I N G
T E X T
When the disc is CD-TEXT
9