Kenwood KNA-DV2100 Installation Manual page 8

Installation
■ Installation of the GPS Antenna
2CAUTION
GPS antenna E can be installed either inside or outside of the car, but either way it should be
•
installed as horizontally as possible to allow easy reception of the GPS satellite signals.
The reception conditions of the GPS satellite will be less favorable with installation inside the
•
car as compared to outside the car. Depending on the type of car, reception of the GPS satellite
signals might not be possible with an inside installation. Installation outside of the car is
recommended if circumstances allow.
• The GPS antenna should be installed at a position that is spaced at least 12 inch (30 cm) from
cellular phone or other transmitting antennas. Signals from the GPS satellite may be interfered
with by these types of communication.
• Do not remove the tape from the back of the GPS antenna. When the tape comes off, the
waterproof effectiveness is diminished and this may cause a fault in the GPS antenna.
Painting the GPS antenna with (metallic) paint may cause a drop in performance.
•
■ Installation Outside the Car
Installation to the trunk lid is made with the GPS antenna E
built-in magnet.
1. Affix the waterproof pad that accompanies E at the
place that comes up against the waterproof rubber lining
the trunk.
2. Draw the cable of E from the trunk lid into the trunk.
■ Installation Inside the Car
Install at a place close to the window surface at the center of
the rear tray or on the inside of the rear window to allow easy
reception of the GPS satellite signals.
●
Installation to the rear tray
1. Peel off the release paper of F and affix to placement
position of E.
2. Place E on F.
8
E
E
F