802.1P & 802.1Q; 180 - D-Link D-View 5.1 User Manual

D-View 5.1 User's Guide
802.1P & 802.1Q
802.1P
Use the 802.1P side menus to view and set 802.1P port priority as well as GMRP and
GARP settings. The read-only Port Capability Form is accessed as a side menu.
802.1P/802.1Q (RFC 2674) MIBs
1pPriority Group
This group contains the objects for configuring and reporting status of priority-based
queuing mechanisms in a bridge. This includes per-port user priority treatment,
mapping of user priority in frames into internal traffic classes and outbound user
priority and access priority.
1pGarp Group
This group contains the objects for configuring and reporting on operation of the
Generic Attribute Registration Protocol (GARP).
1pGmrp Group
This group contains the objects for configuring and reporting on operation of the GARP
Multicast Registration Protocol (GMRP).
Dot1qBase Group
This mandatory group contains the objects, which are applicable to all bridges
implementing IEEE 802.1Q virtual LANs.
The dot1qTp Group
This group contains objects that control the operation and report the status of
transparent bridging. This includes management of the dynamic Filtering Databases for
both unicast and multicast forwarding. This group will be implemented by all bridges
that perform destination-address filtering.
The dot1qStatic Group
This group contains objects that control static configuration information for
transparent bridging. This includes management of the static entries in the Filtering
Databases for both unicast and multicast forwarding.

180