Table of Contents
Advertisement
D-View 5.1 User's Guide
The statistics table lists the values of the various UDP counters of the device. Except
for the Index column, all columns in this table can be resized by dragging their
respective right borders with the mouse left button. The following describes each
column:
The Counters column displays the various UDP statistics counters. For information
about these counters, see the discussion below.
The Total column displays the accumulated count since resetting the statistics
counters. These counters are reset whenever you restart the device or click the Reset
button.
The Rate/s column displays the total count per second.
The Avg Rate/s column displays the average count per second.
The Peak Rate/s column displays the peak count per second.
The Peak Occurred At column displays the date and time when the peak count
occurred.
The Poll Interval buttons set the polling time of the management console. Polling time
determines how often the management console polls the device for statistics. A polling
time of 5 seconds for example means that the management console polls the device
every five seconds to retrieve statistics values. These values are then processed and
displayed on the table. To increase the polling time, click the up-arrow button; to
decrease, click the down-arrow button.
The Reset button resets all UDP statistics counters back to zero.
The Pause button pauses device polling.
The Resume button resumes device polling. The following describes the various UDP
counters:
UdpInDatagrams is a read-only MIB object of the udp group that displays the number
of UDP datagrams delivered to UDP users.
UdpNoPorts is a read-only MIB object of the udp group that displays the number of
received UDP datagrams for which there was no application at the destination port.
UdpInErrors is a read-only MIB object of the udp group that displays the number of
received UDP datagrams that cannot be delivered due to lack of application at the
destination port.
UdpOutDatagrams is a read-only MIB object of the udp group that displays the
number of UDP datagrams sent by the device.
SNMP Counters
This command displays the values of the device SNMP counters.
130
Advertisement
Table of Contents
