Rmon Event - D-Link D-View 5.1 User Manual

D-View 5.1 User's Guide

RMON Event

The Event Group controls the generation and notification of events. Each entry in the
Event Table describes the parameters of the event that can be triggered. Each event
entry is fired by an associated condition located elsewhere in the MIB – in the case of
this software utility, the Alarm Group.
Event Table Tab
The Event Table consists of a list of events to be generated when an event is fired. The
event information headings are described below:
♦ Owner – The entity that configured this entry and is therefore using the
resources assigned to it.
♦ Index – An index that uniquely identifies an entry in the event table. Each such
entry defines one event that is to be generated when the appropriate conditions
occur.
♦ Description – A comment describing the event entry.
♦ Type – The type of notification that the probe will make about the event. In the
case of log, an entry is made in the log table for each event. In the case of snmp-
trap, an SNMP trap is sent to one or more management stations.
♦ Community – If an SNMP trap is to be sent, it will be sent to the SNMP
community specified by this octet string.
♦ Last Time Sent – The value of sysUpTime at the time the event entry last
generated an event. If this entry has not generated any events, this value will be
zero.
♦ Status – The status of this event entry.
Log Table for Event Index
The Event Log Table is generated and maintained by an Event entry in the Event Table
and cannot be manipulated by any other entity. Log entries are described by the
following:
♦ Description – This contains a description of the event that activated this log
entry.
♦ Log Index – The event entry that generated this log entry.
♦ Log Time – The value of sysUpTime when this log entry was created.
177