CARE AND MAINTENANCE
1. Keep your learning computer clean by wiping it with a slightly damp cloth.
2. Keep your learning computer out of direct sunlight and away from direct sources
of heat.
3. Remove the batteries when your learning computer will not be in use for an
extended period of time.
4. Do not drop your learning toy on hard surfaces or try to dismantle it.
5. Do not immerse your learning toy in water or get it wet.
IMPORTANT NOTE:
Creating and developing electronic learning computers is accompanied by a
responsibility that we at VTech
ensure the accuracy of the information that forms the value of our products.
However, errors sometimes can occur. It is important for you to know that we
stand behind our products and encourage you to call our Consumer Services
Department at 1-800-521-2010 in the U.S. or 1-800-267-7377 in Canada. With
any problems and/or suggestions that you might have. A service representative
will be happy to help you.
FCC NOTICE:
This equipment generates and uses radio frequency energy and if not installed and
used properly, that is, in strict accordance with the manufacturer's instructions, it may
cause interference to radio and television reception. It has been type tested and
found to comply within the limits for a Class B computing device in accordance with
the specifications in Subpart J of Part 15 FCC Rules, which are designed to provide
reasonable protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause interference to radio or television reception (which can
be determined by turning the equipment off and on) the user is encouraged to try
to correct the interference by one or more of the following measures:
• reorient the receiving antenna
• relocate this product with respect to the receiver
• move this product away from the receiver
®
take very seriously. We make every effort to
13
Need help?
Do you have a question about the Knowledge Key PC and is the answer not in the manual?