Battery Installation & Charging - AT&T E5827 User Manual

Getting started
Battery installation & charging
After installing the battery, you may be able to make or receive short calls. For
best performance, place the handset in charger to charge for 6 hours before
use.
You can keep the battery charged by returning the handset to the charger after
use. When the battery is fully depleted, a recharge takes about 2 hours. The
average talk time on a fully charged battery is about five hours, and the standby
time is approximately six days. Actual battery life depends on usage conditions
and age of battery.
. Plug the small end of
the smaller power adapter
into the jack on the under-
side of the charger, then
route the cord through the
slot as shown.
6. You may be able to make or receive
short calls. For best performance, place
the handset in charger to charge for at
least 6 hours before first use.
Battery low indicator
Return the handset to the
charger to recharge when this
symbol flashes and the hand-
set beeps or when the hand-
set screen displays NEEDS
RECHARGING.
Caution: Use only the supplied rechargeable battery or replacement battery 2422 (SKU 23402,
part number 89-0047-00-00) or equivalent.
our website at www.telephones.att.com or call 1 (800) 222-3111.
In Canada dial 1 (866) 288-4268.
2. Plug the large
end of the smaller
power adapter into
an electrical outlet
not controlled by a
wall switch.
3. Insert the plug as indi-
cated. Be sure to securely
insert the plug, making
sure that it matches the
color-corded label inside
the battery compartment.
BATTERY LOW
then
10:08 02/14
AM
NEEDS RECHARGING
NOTE: Under normal conditions, the
battery should last approximately one year.
This may vary depending on usage.
To order a replacement battery, visit
7
4. Place the bat-
5. Slide the bat-
tery and wires
tery compart-
inside the com-
ment cover up
partment.
until it clicks.
To replace the battery,
press in and downward
on the tab of the bat-
tery compartment to
open the battery com-
partment cover. Lift
out the old battery
and disconnect it from
the handset. Follow
the instructions on
this page to install and
charge the new battery.