Advertisement
O P E R A T I N G R A N G E
This cordless telephone operates at the
maximum power allowed by the Federal
Communications Commission (FCC).
Even so, the handset and base can
communicate over only a certain distance
—which can vary with the locations of the
base and handset, the weather, and the
construction of your home or office.
If the handset is moved to a point where
the base and handset can no longer
communicate, the handset will sound two
short beeps when you make a call,
indicating that you are out of range. Move
close to the base to restore normal
2
User's Manual
for Cordless
Telephone 7230
Fold open this manual for information about this
telephone's installation and operation. Please
read Part 1— Important Product Information,
included in this package.
If you receive a call while you are out of
range, the handset might not ring — or if
it does ring, the call might not connect
when you press P. Move closer to the
base, then press P to answer the call.
If you move out of range during a phone
conversation, you will hear noise or
interference. To improve reception, move
closer to the base.
If you move out of range while on a call,
the phone will be left "off the hook." To
hang up properly, walk back into range,
periodically pressing P until the
PHONE light goes off.
Part 2
© 1998 Philips Consumer Communications L. P. All rights reserved.
Printed in Mexico. 848233656 Issue 1AT&T
Changing Channels
This cordless telephone has an advanced
25-channel AutoSelect feature that
minimizes the chance of interference.
In the unlikely event that you notice noise or
interference while using the handset:
Press C.
1
2
If the interference does not clear,
continue to press C until you find
a clear channel (your call will not be
interrupted
—OR—
Move closer to the base and press
C.
NOTE: You must be in range to change
channels.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for AT&T 7230
Summary of Contents for AT&T 7230
- Page 1 O P E R A T I N G R A N G E Changing Channels This cordless telephone operates at the If you receive a call while you are out of maximum power allowed by the Federal range, the handset might not ring — or if This cordless telephone has an advanced Communications Commission (FCC).
- Page 2 I N S T A L L A T I O N Modular Jack Standard AC Outlet Base Antenna AC Adapter Charging/Handset in Use Light Power Cord PAGE/HANDSET LOCATOR Button Telephone Line Cord you will always need to press P base goes on to show the handset The instructions below are for both table is in the right position to charge...
- Page 3 O P E R A T I O N Making A Call Handset Volume Press P, and wait for the The handset volume can be set to three different levels. Each time you press V PHONE light to go on steadily. When you hear a dial tone, dial the the level changes.
- Page 4 M E M O R Y Storing Numbers Just Dialed This cordless phone can store 10 telephone Whenever you make a telephone call, you numbers that you can dial just by pressing can store the number you dialed in memory. p and one of the number buttons.
- Page 5 B A T T E R I E S Charging the Handset Replacing the If it’s more convenient for you, you can Battery Pack Handset Battery Pack leave the handset in the base all the time. The batteries need charging when: It is impossible to overcharge the batteries.
- Page 6 I N C A S E O F D I F F I C U L T Y the handset and press P. The If you have difficulty operating this phone, • You might have too many exten- try the suggestions below. If you still have phone should operate properly.
Need help?
Do you have a question about the 7230 and is the answer not in the manual?
Questions and answers